Hi everyone, here are more images.
Today we worked on dry fitting the enclosure, the 0.5 inch thick exterior layer of the back wall, and filleted some of the corners on the port walls. The first image shows us dry fitting the entire enclosure for the first time. The second image shows a very refined idea of what the overall enclosure is going to look like. The third image shows the external layer of the back wall; the back wall is comprised of two layers, a 0.75 inch thick internal layer and a 0.5 inch thick external layer. This will come in handy later when we make an access gate in the back to replace a small light bulb when needed. The light (LED, incandescent, halogen, xenon... we're not sure yet) will accentuate the main chamber, the frame, and motor structure of the subwoofer visible through the viewing window. The fourth image shows a filleted corner of the inner port wall. The fifth image shows a filleted corner of the intermediate port wall.
Rounding or filleting any sharp corners in the port area that high velocity air passes over is critical for the sound quality of a ported enclosure. JL Audio makes a pretty spot on analogy: "The mechanism that gives a whistle its characteristic sound is high velocity air passing over a sharp corner. A sharp corner in a port attributes a similar effect." The thing that plagues ported enclosures with ports without filleted corners is a low pitch whistling sound. This is actually caused from turbulence of the propagating air at the unrounded corners. Conversely, a rounded corner subjected to high velocity air will promote a laminar (smooth) passage of air exiting the port.



Reply With Quote